|
Post by Admin on Jan 31, 2007 11:39:12 GMT -8
Ah yes. I am asked this many times so I'm going to put it here.
How to make a clickable signature on DN1 =============================
The following are for using a signature from the Generic Signature Vault in the media section. ------------------------------------------------------------------
Click Profile on DN1. (It's up at the top.)
Go down to where it says signature.
Copy and paste the following in there:
For TTB:
<a href="http://ttbgamers.co.nr/"><img border="0" src="http://members.shaw.ca/tjmcq/genericsigs/filename.jpg"></a>
For The Pride:
<a href="http://thepride.co.nr/"><img border="0" src="http://members.shaw.ca/tjmcq/genericsigs/filename.jpg"></a>
Then replace filename.jpg with the name of the desired signature from the generic signature vault.
All Other Signatures -------------------------
Copy and paste the following to DN1 like above:
<a href="http://www.yoursite.com/"><img border="0" src="http://www.yoursite.com/myfiles/signature.jpg"></a>
Then replace yoursite.com with the address of the destination website. Then replace yoursite.com/myfiles/signature.jpg with the location and filename of your signature image.
If you want a border around your signature, which most people don't, change border="0" to border="1". This will give you a border of 1 pixel. For further instructions on border colour and stuff like that refer to an html tutorial.
|
|
|
Post by Admin on Jan 31, 2007 11:40:27 GMT -8
And don't forget to "Save" the settings.
|
|
|
Post by Catzi on May 2, 2007 12:58:18 GMT -8
|
|
|
Post by Admin on May 13, 2007 9:08:25 GMT -8
|
|